C70 Coupe L5-2.3L Turbo VIN 53 B5234T3 (2001)
-
Check locating pin rubber bushings. Replace as necessary
-
Grease locating pins with Volvo silicon grease (PN 116 1325-4) and insert them in rubber bushings (4). Pin should slide easily into bushings.
Installation of brake caliper and brake pads
-
Push piston back in cylinder on brake caliper.
-
Check that dirt guard is positioned correctly.
-
Install new brake pads and install brake caliper.
-
Tighten locating pins to 30 Nm (22 ft.lb) and install protective caps.
-
Install retaining spring (3).
Finishing and checking
-
If brake hose was not unscrewed, Check brake fluid level.
-
If brake hose was unscrewed, tighten brake hose onto brake caliper to 18 Nm (13 ft.lb)
NOTE: Make sure that hose is not twisted. There is a white line running along the hose which shows if the hose is twisted. Correct at other end of
hose if necessary.
-
Top up and bleed braking system. Then continue as below.
-
Check that there are no leaks and that brakes are working properly.
Checking brake fluid level
-
Push brake pedal down a few times.
-
Check level in brake fluid reservoir. Top up brake fluid if necessary.
Installation of wheel
