C70 Coupe L5-2.3L Turbo VIN 53 B5234T3 (2001)
-
In cars with SRS, remove kneeguard.
-
Disconnect brake pedal from support bracket by removing locking spring.
-
Remove locking washer, bushings and brake pedal.
Installing
-
Grease new bushings with grease 116 1241-3.
-
Install new bushings.
-
Install brake pedal and a new locking washer.
-
Connect brake pedal to support bracket by locking spring.
-
In cars with SRS, install kneeguard, tighten to 20 Nm (15 ft.lb).
-
Install sound insulation.
Replacing the Master Cylinder
Replacing the master cylinder
Preparations
Clean around brake fluid reservoir cap, by pipe connections, and, if necessary, by hose connection between reservoir and master cylinder to prevent dirt
entering braking system.
Caution! Release non-return valve in air hydraulic brake power assist unit (brake servo) or pump brake pedal until it goes hard to avoid any
vacuum remaining when undoing the master cylinder. Otherwise, there is a risk that the O-ring acting as a seal will be sucked into the servo
and disappear.
Put rags under master cylinder to prevent brake fluid spillage on paint work surfaces.
Note! Do not open the master cylinder under any circumstances. It takes special equipment and facilities to reassemble.
Removing master cylinder
Ignition off.
Remove:
-
Brake fluid reservoir as per. Brake fluid reservoir, replacement and cleaning.
