C70 Coupe L5-2.3L Turbo VIN 53 B5234T3 (2001)
-
the upper torque rod.
Tighten to 35 Nm (26 lb.ft) . Angle-tighten 90 degrees .
Use bevel protractor: 951 2050 BEVEL PROTRACTOR See: Tools and Equipment/951 2050 Bevel Protractor
-
the cover over the ignition coils.
Tighten to 8 Nm (6 lb.ft) .
-
the charge air pipe over the engine.
Remove the seals.
-
the air cleaner (ACL) cover and the intake air hose.
-
the solenoid valves on the air cleaner (ACL) cover.
-
connect the battery negative terminal. Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery,
Disconnecting.
Check the engine compartment and wipe it clean.
Checking the engine
Check the engine function by test driving the car.
Wipe the steering wheel and gear selector lever clean.
Variable Valve Timing Solenoid, Replacing
Variable valve timing solenoid, replacing
All models
Removing the variable valve timing (VVT) control valve
Remove
-
the upper timing belt cover.
Note! Clean the area around the variable valve timing (VVT) valve thoroughly to prevent anything else than clean oil from entering the
channels/ variable valve timing (VVT) valve.
