C70 Coupe L5-2.3L Turbo VIN 53 B5234T3 (2001)
Valve Clearance: Adjustments
Valve Clearance, Checking
Checking valve clearance
Note! As the illustrations in the information are used for different model years and / or models, certain variations may occur. However, the
essential information in the illustrations is always correct.
Preparation
Remove, (turbocharged engines)
-
charge air pipe above the engine and holder at the rear of the engine.
-
cover intake camshaft.
-
clamp the injectors cable harness.
Remove (common)
-
the upper timing cover.
-
the cover over the ignition coils.
Remove (naturally aspirated engine)
-
the inlet hose between the air cleaner (ACL) and throttle body (TB).
-
the crankcase ventilation hose from the inlet hose. Place the inlet hose to one side.
-
the camshaft position (CMP) sensor housing. Put to one side.
-
the trigger wheel.
Remove (common)
-
the ignition coils without removing the connectors.
Note! Mark up before removal!
-
the two ground connections.
-
the connector for the VVT solenoid.
-
the right front wheel.
-
the plastic nuts holding the cover for the fender liner.
Set the engine to the test position
