volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Procedures|Page 7847 > < Application and ID|Page 7844
Page 1
background image

Catalytic Converter: Procedures

Replacing The Three-way Catalytic Converter (TWC)

Special Tools:  999 5543, 999 5972.

NOTE:  As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information in the illustrations is always correct.

Removing The Three-way Catalytic Converter (TWC)

Remove

-

the left front wheel. Applies to B52x4T.

Disconnect the heated oxygen sensor (HO2S) connectors.

Release the heated oxygen sensor (HO2S) wiring from its mountings.

NOTE:  Applies only to B52x4T:

Remove the lower rear screw for the heat deflector plate above the turbocharger (TC).

-

the nuts for the front exhaust system connection to the turbocharger/manifold.

-

the SIPS member.

-

the clamp where the exhaust system divides downstream of the three-way catalytic converter (TWC).

Lift off the exhaust pipe from the turbocharger (TC)/manifold and the rear system.

Lower/draw down the exhaust system.

HINT:  Use a mobile jack with universal plate 999 5972 as support.

Transferring Components

Procedures|Page 7847 > < Application and ID|Page 7844