volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Electronic Throttle Control Module|Service and Repair|Page 14131 > < Electronic Throttle Control Module|Service and Repair
Page 2
background image

-

Remove the support bracket for the starter motor.

-

Disconnect the throttle body (TB) connector.

-

Remove the mounting screws from the throttle body (TB). Lift up the throttle body (TB). Clean the mating surfaces thoroughly.

Installing The Throttle Body (TB)

Install

-

the bracket for the starter motor.

-

a new throttle body (TB) with a new gasket. Tighten to 17 Nm. 

Connect the throttle body (TB) connector.

Clamp the cable in the bracket for the starter motor. Use a tie strap.

Electronic Throttle Control Module|Service and Repair|Page 14131 > < Electronic Throttle Control Module|Service and Repair