C70 Coupe L5-2.3L Turbo VIN 53 B5234T3 (2001)
If the shaft journal is showing signs of wear, the seal can be pressed in 2 mm (0.079 in) deeper by turning the drift socket.
Reinstall
Install:
-
the trigger wheel. Tighten to 17 Nm (12 lb.ft).
-
the camshaft position (CMP) sensor housing and a new cover. Tighten to 10 Nm (7.4 lb.ft).
-
the torque rod bracket. Tighten to 50 Nm (37 lb.ft).
-
the upper torque rod. Tighten to 35 Nm (26 lb.ft). Angle-tighten 90 degree.
Use bevel protractor: 951 2050.
-
the cover over the ignition coils. Tighten to 8 Nm (6 lb.ft).
-
the charge air pipe over the engine.
Remove the seals.
-
the air cleaner (ACL) cover and the intake air hose.
-
the solenoid valves on the air cleaner (ACL) cover.
-
connect the battery negative terminal.
Check the engine compartment and wipe it clean.
Checking The Engine
Check the engine function by test driving the car.
Wipe the steering wheel and gear selector lever clean.
