C70 Coupe L5-2.3L Turbo VIN 53 B5234T3 (2001)
-
Secure wiring.
-
Lower the car slightly.
-
Connect the connectors.
-
Secure wiring.
-
Install LH front wheel. Tighten to 110 Nm (81 ft lb).
Lower the car.
Adapter Wiring Switch, Replacing
ADAPTER WIRING SWITCH, REPLACING
Removal and Installation
Removing heated oxygen sensors (HO2S)
The connectors for the heated oxygen sensors (HO2S) are on the transmission.
Preparations
Switch off the ignition.
Remove the air cleaner (ACL) housing.
Detach the inlet hose between the air cleaner (ACL) and the turbocharger (TC) from the turbocharger (TC).
Open the catches and disconnect both the connectors for the heated oxygen sensors (HO2S).
Heated oxygen sensors (HO2S), removing
See Heated oxygen sensor (HO2S), replacing, See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Component Tests
and General Diagnostics/Component Access/Replace Procedures/Heated Oxygen Sensor (HO2S), Replacing
