C70 Coupe L5-2.3L Turbo VIN 53 B5234T3 (2001)

Shift Solenoid: Service and Repair
Solenoids/Control System, Replacing
Solenoids/control system, replacing
Replacing/checking solenoids
Preparation
Note! The steps regarding the cable harness and connections, and mountings for the solenoids/control system should not be performed if
changing the solenoids or control system.
Remove, see Replacement of control system cable harness with oil temperature sensor See: Automatic Transmission/Transaxle/Sensors and Switches -
A/T/Transmission Temperature Sensor/Switch/Service and Repair/Replacement Of Control System Cable Harness With Oil Temperature Sensor.
Unplug the solenoid connectors.
Checking the resistance of S1-S5
Location Of Components (Solenoids)
Note! Measurements should be taken at approx. 20°C.
Solenoid S1
Measure between the pin in the solenoid connector and the transmission grounding point.
Correct value: 12-16 ohms.
Solenoid S2-S5
Measure between the pin in the solenoid connector and the transmission grounding point.
Correct value: 11-15 ohms.
If the value for any of the solenoids S1-S5 is incorrect
Replace the solenoid as described in Replacing solenoids S1-S5.
Checking the resistance of SLT, SLS and SLU