C70 Coupe L5-2.3L Turbo VIN 53 B5234T3 (2001)
Continued
Reconnect the motor connector and switch on the ignition.
Run the window up so that the adjustment screw on the carriage (A) is just in contact with the stop at the top of the door.
The front stop must stop 2 mm (see the distance (C) in the illustration) before the rear stop. If the front stop stops first the motor continues so that the
rear stop reaches the top.
The distance between the lower edge of the rail and the lower edge of the carriage should be 25 mm greater than the corresponding distance at the other
carriage. See Replacing the lift mechanism motor and mechanical cable for side window .
Mark the wire on the bottom edge of the carriage (B) with a marker pen.
Run the window down a little.
Tighten the screw locking the carriage (B) to the wire at the marker pen marking.
If necessary adjust the adjustment screw on the carriage (A).
Align the door mirror so that there is a straight line between the door and the door mirror. Check the seal between the door mirror and the weatherstrip.
Check for leaks between the window and weatherstrip according to Checking the seal, front side window.
