volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Procedures|Page 33643 > < Procedures|Page 33641
Page 10
background image

Install the windshield.

Install: 

-

the guide molding at the lower edge

-

the windshield washers and the cowl. See

-

the moldings on the A-posts.

Note! Park the car on an even surface. Cure for three hours at a minimum temperature of +5°C otherwise apply extra heat. 

Bonded Window General, Information

Bonded window general, information 

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
 

Installation 

Installing bonded windshield 

Warning! All fixed windows are PUR bonded. PUR adhesive can cause asthma like symptoms. Isocyanate vapor from uncured primer or
adhesive can cause allergies in the respiratory tract. Once you have acquired an allergy the quantities required to trigger a reaction are very
small The risk remains until the material is cured. Cured PUR adhesive can degrade if subjected to high temperatures and isocyanide
compounds can be released when grinding or welding.  Ensure that ventilation is good. Use a fresh air mask  Never touch the adhesive surface
with your fingers  Use protective gloves
 

Note! Securely installed windows are part of the collision safety concept. Always use original PUR adhesive kits! These are selected and tested
by VOLVO. They are the only ones for which VOLVO Car Corporation takes responsibility.
 

Note! When bonding windshields, only Volvo's aftermarket adhesive is approved. This adhesive is continually tested to satisfy Volvo's demands
on the vehicle in the aftermarket environment.
 

Vehicles with a driver's airbag (SRS) and/or passenger airbag (SRS) must be bonded using 2-component adhesive.
If the windshield has been bonded with an adhesive that has not been approved by Volvo, this adhesive should be removed. This is because there are
adhesives to which no PUR adhesive will bond.

Place the windshield on a stand.
Apply the suction pads/winches.

Note! Always keep a side window open when bonding the windshield. Otherwise it can move out of position when closing a side door. 

Procedures|Page 33643 > < Procedures|Page 33641