S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
-
Carefully lower the control module and ABS hydraulic modulator.
The brake pipes will follow at the same time. Do not damage the brake pipes
-
Install the 3 rubber dampers and the 2 mounting lugs
-
Tighten the 2 mounting nuts. Tighten to 25 Nm (E).
Install:
-
the connector for the control module (D)
-
the fluid reservoir (C) for the power steering system
-
the mounting clamps (B) for the brake pipes. Ensure that the brake pipes are correctly positioned in the rubber mounting
-
the hose mounting and the hoses (A).
Checking the function of the ABS system
Read off and erase any diagnostic trouble codes (DTCs).
Test drive according to Test driving See: Testing and Inspection/Initial Inspection and Diagnostic Overview.
Check whether any diagnostic trouble codes (DTCs) have been stored. Read off any stored DTCs.
Check whether any diagnostic trouble codes (DTCs) have been stored. Read off any stored DTCs.
Replacing the ABS Hydraulic Modulator and Control Module
Replacing the ABS hydraulic modulator and control module
Note! For service work, the modulator is supplied with the control module. The secondary modulator circuit is filled with brake fluid. The
circuit is internally bled so that the brake system can be bled in the normal way after assembly.
Removal
Preparations
Ignition off.
Removing the control module