S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Brake Bleeding: Service and Repair
Bleeding brake system
Bleeding guidelines
Mechanical bleeding is usually sufficient when overhauling or replacing brake calipers. If the brake pedal is depressed during this operation, no brake
fluid will flow out of the system.
The brake system can be bled both mechanically and by means of overpressure.
Note! After a brake caliper is repaired it only needs to be bled for a short time; longer in the case of repairs to the master cylinder and ABS
module.
Brake fluid quality
Use only original Volvo brake fluid with the (minimal) code DOT 4+. Never re-use brake fluid. Always store brake fluid in its original packaging,
carefully closed.
Preparing for bleeding
The ignition must be switched off.
Clean the cap of the brake fluid reservoir and the surrounding area.
Remove filler cap.
Bleeding brake system by overpressure
Connect the bleed unit to the brake fluid reservoir. Follow the manufacturers' instructions for connecting and using the unit.
Bleeding brake system
Note! Begin bleeding with one of the rear wheels.
Bleed in the following order:
-
Rear right
-
Rear left
-
Front right
-
Front left