S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
-
the ignition coils and ignition cables according to earlier markings
-
the ground lead for the ignition coils
-
the camshaft position (CMP) sensor.
Place the cable duct and cable harness in position.
Install:
-
the screws for the cable duct on the rear edge of the cylinder head and throttle body (TB) bracket
-
the bracket between the intake manifold and the power steering pump
-
the connectors for the injectors
-
the connector for the engine coolant temperature (ECT) sensor
-
the air preheating hose between the air cleaner (ACL) and the heat deflector plate for the exhaust manifold
-
the auxiliaries belt
-
the pipe screw for the water-heated crankcase ventilation
-
the upper section of the air cleaner (ACL) housing and hose
-
the EVAP hose connection to the mass air flow (MAF) sensor hose
-
the connector for the mass air flow (MAF) sensor
-
the turbocharger (TC) control valve on the air cleaner (ACL) housing
-
the brake servo vacuum hose
-
the throttle cable
-
the inlet hose between the mass air flow (MAF) sensor and throttle body (TB)
-
the front timing cover
-
the cover over the ignition coils
-
the upper timing cover
-
the cover over the throttle body (TB)
-
the cover over the injectors.
Installing the fuel line
Press the fuel line into the quick-release connector on the fuel rail.
Installing the exhaust manifold
Normally aspirated engine