S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Removing the oil pump
-
Remove the four oil pump screws
-
Remove the oil pump.
Use a groove-cut chisel and carefully break at the stop lugs
-
Clean the gasket face and the mating surfaces.
Installing the oil pump
Install the new oil pump.
-
Install a new gasket
-
Carefully insert the oil pump over the end of the crankshaft.
NOTE: Do not damage the sealing ring in the oil pump during installation.
-
Install 4 new screws as guides
-
Pull in the oil pump with drift 999 5455 and the crankshaft center nut.
NOTE: Ensure that the crankshaft does not rotate when drawing in the pump.
-
Tighten the screws crosswise. Tighten to 10 Nm
-
Install the crankshaft timing gear pulley.
Carefully tap alternately around the pulley until end position is reached.
NOTE: The timing gear pulley can only be in one position on the splines on the end of the crankshaft.
Installing the vibration damper