S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
-
Clean the mating surfaces
-
Position the end of the front pipe in the rear pipe
-
Install a new gasket. Tighten the front pipe to the three-way catalytic converter (TWC). Tighten the nuts. Tighten to 25 Nm
-
Hang up the exhaust system. Tighten the clamp on the rear exhaust pipe. Tighten to 60 Nm
-
Install the rear engine cover
-
Install the rear floor hatch. Use grease, P/N: 1161408.
Turn the heated oxygen sensor (HO2S) the same number of turns as when removing it.
Tighten to 55 Nm.
Replacing the Front Exhaust Pipe
Replacing The Front Exhaust Pipe
Removing the front exhaust pipe
Apply rust solvent to all components.
Remove: