S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
-
Proceed to Length of the stripped section of cable.
If a seal is to be used on the cable terminal
Thread the seal on to the cable before stripping the insulation. If the seal is threaded on to a cable that has been stripped both the copper conductors in
the cable and the seal can be damaged.
-
Push the seal about 5 cm down the cable with the narrow end of the seal pointing towards the cable end. See illustration.
Always use a seal of the correct size for the cable it is intended for.
Length of the stripped section of cable
Volvo recommends the use of stripping pliers with an integral setting for the length of the stripped section and the cable area.
Note! Always used the correct length of stripped conductor to match the cable terminal to be used.
The cable must be stripped to a conductor length that matches the cable terminal type.
Compare the stripped conductor length with the cable terminals crimp contact connection. See illustration.
The stripped length of the cable should be slightly longer than the crimp contact.
-
A normal stripped length of conductor is approx. 4 to 5 mm.
Cable Terminals - Crimping Core Wings
Cable terminals - crimping core wings
Insulated cable terminals
Crimping core wings, shape