S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Incorrect crimping as shown above can be caused by:
-
Stripping the cable too short or too long.
-
Incorrect location in the cable terminal.
-
The cable terminal was incorrectly located in the crimp tool forming section.
Example 1
Example 1
Socket type housings p/n 3523410-3, and equivalent pin housings
Replacement of cable terminals
Remove housing
-
Pull back the rubber cover on the cables
-
Remove rubber gasket (socket housings only).
-
Carefully release the clips by bending them out with a small screwdriver (one clip per side).
-
Depress the catch on the front of the housing and lift the housing out of the connector cover.
Open the housing