S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Press the cut-off cables into the casing without damage or sticking other parts Tape if necessary.
Install the:
-
carpet back into position
-
rear seat
-
side cushion for the backrest
-
sill trim panels
-
connector to the SRS control module
-
center console.
Carry out a final check according to method E.
B7: Replacing the cable harness between the Supplemental Restraint System control module (SRS) and the inflatable curtain, service cable harness 5 or 6
(applies to V40)
Replacing the cable harness
14
Remove the:
-
rear center console
-
complete rear seat
-
side cushion for the backrest
-
rear sill trim panels, left and rear
-
D-post panel
-
panel in the cargo compartment.
Detach the headlining at the rear edge by removing the clips at the side and in the center. See VADIS.
Disconnect the connector from the side impact sensor by pressing in the catches using circlip pliers.
Note!
Do not bend the headlining.