S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
If the connector is intact then first remove the socket housing (female) from the pin housing (male). See illustration.
-
Undo the locking screw. (Some connectors have no locking screw).
-
Turn the connector housing retaining ring (outer ring) counterclockwise.
-
Separate the two halves of the connector.
Extract socket housing
Extract socket housing from the connector housing as follows:
-
Remove retaining ring from the connector by inserting a small screwdriver from the rear of the ring and pry open the 3 catches.
-
Pull back rubber seal on the cables.
Open socket housing