S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
-
Install a new sealing ring. Apply installation paste (P/N 1161035-9) to the entire length of the screw thread.
Tighten the heated oxygen sensor (HO2S). Tighten to 55 Nm
-
Pull the cable upwards.
Installing the heated oxygen sensor (HO2S), cable and connector
NOTE: Adjust the routing of the cable so that it does not come into contact with the exhaust system.
-
Route the cable. Secure the cable to the 3 mounting points
-
Connect the connector. Secure the cable to the bracket
-
Reinstall the relay cover.