S40 L5-2.4L VIN 38 B5244S4 (2004)
Remove:
-
the 6 screws for the upper intake manifold, closest to the front cover plate, and the 2 screws against the firewall
-
the EVAP canister hose on the intake manifold
-
the brake vacuum pipe. Press in the red catch. Pull out the pipe. Disconnect the throttle body (TB) connector and the pressure sensor on the intake
manifold. Cut the tie strap. Lift up the intake manifold and put it to one side.
Removing components from the rear edge of the engine
Remove:
-
the 2 screws for the lifting eyelet at the rear edge of the cylinder head
-
the screw for the clamp for the fuel pressure pipe in the lifting eyelet. Unhook the evaporative emission system (EVAP) valve from the lifting eye.
Disconnect the connector for the heated oxygen sensors (HO2S). Move the lifting eyelet to one side.
Removing the rotor on the camshaft
Note! Clear up any oil spillage using paper.
Remove:
-
the covers in the rear edge of the camshaft. Using a screwdriver, press in the center of the cover. Pry off the cover
-
the rotor screw
-
the rotor.
Mounting the engine
