volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Tape Antenna Cover Navigation System|Page 12522 > < Tape Antenna Cover Navigation System|Page 12520
Page 8
background image

-

Pull off the rubber strip at the rear of the opening for the right-hand rear door

-

Carefully pry off the lower panel on the C-post on the right-hand side. Carefully pry at the top edge. Use a plastic weatherstrip tool

-

Pull the panel on the C-post so that the two upper clips release. Then continue down until the last two clips release. Remove the panel on the
C-post.

-

Fold out the load securing eyelets on the right-hand side panel

-

Insert a scriber with an angled tip into the holes in the top of the covers (1). Turn the scriber so that the tip engages the reverse of the covers. Pull
the covers off

-

Remove the screws in the load securing eyelets

-

Remove the screw (2) at the front/top edge of the side panel

-

Pull off the side panel at the top so that the two clips at the rear/bottom of the side window and the clip at the bottom of the D-post release

-

Disconnect the connector for the 12V socket, if present

-

Lift out the side panel.

-

Remove the right-hand floor support. First remove the three clips at the bottom of the compartment, then lift it up.

Tape Antenna Cover Navigation System|Page 12522 > < Tape Antenna Cover Navigation System|Page 12520