S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
-
Loosen the connector from its position on the inside of the cover panel.
-
Press the movement sensor onto the cover panel and ensure that all the fasteners take hold.
-
Plug in the connector to the movement sensor.
-
Replace the cover panel with the movement sensor in the headlining.
-
Program the function with VCT 2000 in VIDA.
Applies to the V50
-
Remove the cargo compartment carpet.
Removing the sill trim panel from the tailgate:
-
Pry off the four external clips at the front edge/bottom edge of the sill trim panel on the tailgate.
-
Pry up one of the corners of the sill trim panel so that the two clips at that end release. Use a weatherstrip tool.
-
Pull up the sill trim panel so the remaining six clips release. Remove the panel.
-
Detach the rubber strip where it covers the right-hand side panel in the boot opening.
Removing the rear roof panel:
-
Grip the edges of the rear roof panel and pull downwards, so that the nine clips release. Pry using a weatherstrip tool, if necessary.
Note! Do not damage the panels.