S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
-
Check the bend radius of the fibre optic cables. If the bend radius is less than 25 mm (1"), remove the tape from the thick cable harness and
increase the radius.
Connecting the power supply cable
Illustration A
-
Take the T-cable for power supply (A in the kit illustration).
Connectors:
-
to the subwoofer (1)
-
to the pre-routed single pole connector (2)
-
to the connector detached from the amplifier (3)
-
to the amplifier (4)
Illustration B
Note! The previously installed fibre optic cable is not illustrated.
-
Plug connector (1) into the rear end face of the subwoofer.
-
Plug the connector (2) into the pre-routed black connector (5) which is taped on the cable harness at the rear edge of the left-hand rear wheel arch.
-
Detach the existing connector in the amplifier and plug it into connector (3) in the T-cable.
-
Plug the remaining connector (4) in the T-cable to the amplifier.
-
Clamp the relay (6) and all loose connectors in at the car's existing cable harness to prevent rattling.
