S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
-
Apply activator P/N 8637076 and apply butyl tape on the marked locations.
-
Affix the first cable harness by the two center sensors to the butyl tape.
-
Secure the rest of the cable harness to the butyl tape starting on the left-hand side.
Applies to right-hand drive cars
-
Secure the rest of the cable harness to the butyl tape starting on the right-hand side.
Cable routing
Note! Steps 32-40 show a left-hand drive car. For right-hand cars carry out the steps on the left-hand side of the car.
-
Take the short cable from the kit
-
Pull the end with the loose terminal pins in under the headlamp
-
Continue to pull the cable (1) along the right-hand side of the car, under the expansion tank down to the cowl panel.
-
Route the cable so that it is concealed and cannot be damaged or worn. Secure the cable so that it does not move.
Note! Ensure that the cable does not lie against any moving components or too close to heat sources.