S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
-
Pierce holes through the insulation and out into the engine compartment, for hole-marking in the insulation panel.
-
Cut out a hole in the heat insulation that is approx. 20 mm larger than the size of the rubber grommet.
Applies to cars with fuel-driven parking heater:
Caution! Protect the coolant hose on the water pump's horizontal connection when hole-marking.
-
Take the rubber grommet from the kit and cut the top off the smaller rubber nipples
-
Lubricate the rubber grommet. Use low temperature grease P/N 1161417.
-
Thread the cable through the hole in the rubber grommet. Install the rubber grommet in the hole.
Applies to cars with a passenger compartment heater and where an existing rubber grommet is used
-
Cut off the top of one of the smaller rubber nipples
-
Thread the cable through the hole in the rubber grommet.