S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
-
Make 4 holes in the bumper cover using the hole tool. Place the cutting part of the tool on the outside of the bumper cover.
-
Screw the hole tool together until it has cut the hole in the bumper cover.
-
Remove the plastic pieces from the hole tool and make the other holes in the sane way. Cut away the excess on the inside of the holes.
-
Clean the top of the inside of the bumper cover using a mild soap solution.
-
Clean an area around the holes that is slightly larger than the sensor holder. Use isopropanol. Allow to dry.
-
Apply a thin and even coat of activator to the cleaned surfaces. Allow to dry for at least 10 minutes.
-
Check which holders are to be placed where before installing. Each holder is marked and has its own specific place. The holders must be
positioned as illustrated.
1. 1 Right outer
2. 2 Right inner
3. 3 Left inner
4. 4 Left outer