S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
-
Release the connector from its position on the inside of the panel
-
Press the movement sensor into place in the cover. Ensure that all the catches engage
-
Connect the connector for the movement sensor
-
Reinstall the cover and the movement sensor in the headlining
-
Program the function using VCT2000 in VIDA.
Applies to the V50
-
Remove the cargo compartment carpet.
Removing the sill trim panel from the tailgate:
-
Pry off the four external clips at the front edge/bottom edge of the sill trim panel on the tailgate
-
Pry up one of the corners of the sill trim panel so that the two clips at that end release. Use a weatherstrip tool
-
Pull up the sill trim panel so the remaining six clips release. Remove the panel
-
Detach the rubber strip where it covers the right-hand side panel in the boot opening.
Removing the rear headlining:
-
Grasp the edges of the rear headlining. Pull downwards so that the nine clips release. Pry using a weatherstrip tool if necessary.
Note! Do not damage the panels.