S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
-
Remove the locking washer. Unscrew the locking screw for the spare wheel mounting from the plastic cone. Place the screw to one side
-
Take the new long screw from the kit. Install the screw in the plastic cone. Lock using the locking washer.
-
Tighten the spare wheel using the new screw and the plastic cone.
-
Install the new supports for the floor in the cargo compartment from the kit in place of the old ones
-
Reinstall the side panel in the cargo compartment. Tighten the screws for the load securing eyelets. Tighten to 24 Nm (18 lbf.ft)
-
Reinstall the panel at the front edge of the side panels
-
Reinstall the tailgate sill trim panel
-
Reinstall the C-post panels
-
Reinstall the rubber strips at the rear edge of the rear doors
-
Reinstall the side cushions
-
Position the backrest and seat cushions back into place.
Applies to the V50 with subwoofer
-
Lift out the support for the floor in the cargo compartment.