S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Front Bumper Reinforcement: Service and Repair
Bumper rail, front
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Removal
Removing the front bumper rail
Remove the front section. See: Front end See: Radiator Support/Service and Repair.
Remove the bracket for the power steering. It is secured using 4 M8 screws.
Hang up the unit using wire.
Remove:
-
the front screw, 1 x M6, for the washer reservoir
-
the horn. It is secured using 2 M6 screws
-
the cable harness and washer hose from the bumper rail.
Note! Note how the washer hose and cable are routed on the rail.
Support the radiator assembly. Detach the radiator. It is secured using 4 M8 screws.
Remove the remaining 6 M8 screws for the bumper rail. Remove the bumper rail.
Installation
Note! For tightening torques, see Specifications. See: Specifications
Installing the front bumper rail