S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Drill or grind out the spot welds.
Cut off the damaged section.
The member can also be joined at (1).
Note: If the inner section is joined, the distance between the joins must be at least 50mm.
Removing the inner section of the upper side member
Drill or grind out the spot welds.
Cut off the damaged section.
Installing the inner section of the upper side member
Grind clean.
Apply welding primer.
Secure the upper side member.
Spot-weld the replacement part.
Tip diameter against the suspension turret: 6 mm.
Tip diameter against the wheel arch: 4.5 mm.
Carry out finishing work. See: Finishing work (common to both methods).