S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Transfer:
-
the high-level stop lamp (1). It is hot-bonded outside the vehicle
-
the surround (2) for the cover for the mass movement sensor (MMS). It is hot-bonded outside the vehicle
-
the cable harness. It is taped in position inside the vehicle. Use tape P/N 951 1099.
Installation
Installing the headlining
Install the sun roof molding (if applicable) on the sun roof frame.
Note! Use a new molding.
Insert the headlining through the windshield opening.
Tape the cable harness to the headlining according to notes made above.
Install:
-
the 3 clips in the rear edge of the headlining
-
the cover for the mass movement sensor (MMS)
-
the molding around the sun roof, if applicable
-
the grab handles
-
the C-post upper panel. See: C-pillar trim panel See: Trim Panel/Service and Repair/C-Pillar Trim Panel
-
the A-post panel. See: A-pillar trim panel See: Trim Panel/Service and Repair/A-Pillar Trim Panel
-
the rear courtesy lighting. See: Rear interior light See: Lighting and Horns/Dome Lamp/Service and Repair/Rear Interior Light
-
the front courtesy lighting. See: Lighting, internal front See: Lighting and Horns/Dome Lamp/Service and Repair/Lighting, Internal Front
-
the sun visors. See: Sun visor See: Sun Visor/Service and Repair/Sun Visor.
Secure the headlining to the molding around the sun roof using the pull-cord.
Install the windshield. See Windshield See: Windows and Glass/Windshield/Service and Repair/Windshield.
