S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
-
Wrap the section of the roof trim to be secured in the vice. Use plenty of paper or cloth to protect the paintwork on the roof trim
Note! Use jaw protectors with a recess in the centre on the vice.
Position the roof trim in the recesses in the vice.
Note! Do not over-tighten the vice or the roof trim may deform.
-
Carefully cut at the marking furthest in on the roof trim, gently pressing the roof trim. Hold the other end of the roof trim with your free hand to
keep the trim stable whilst cutting.
-
Remove the long section of the roof trim from the vice
-
Secure the cut off section with the section (1) to be cut off in the vice
-
Cut the roof trim in the same way as in the previous point.
-
Smooth off the two shorter end pieces and the long section of the roof trim. Use a fine toothed file
-
Remove the swarf from the different sections
-
Check that the rubber strips are seated in their grooves. If necessary use a small screwdriver to press the trim strips back into the grooves by the
protruding ends
-
Repeat points 5-13 on the left-hand roof trim.
Installing the roof trim
