S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Installation
Installing the styling roof rails
Remove dirt and dust from the area for the seal.
Use a clean, lint-free cloth or similar.
Install the seals on the styling roof rails, 2 on each side.
Note! Replace the foam seals if they are damaged.
Locate the styling roof rails in the correct position on the roof.
Screw in the 4 M6 screws on each side, only 2 turns.
Check that the screw threads engage.
Hint: Tighten the screws in 2 stages to prevent misalignment.
Tighten the screws according to Tightening torque See: Specifications.
Caution! Do not exceed the tightening torque, since the seal can lose its function.
Install:
-
the front covers, 1 on each side.
-
the rear covers, 1 on each side.