S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
When the heater pad has been bonded into place the positional straps (gray in the illustration) must be cut apart. This only applies to those types of heater
pads that have positional straps.
NOTE: The positional straps must not be cut before bonding is complete.
Checking bonding
This check can be performed either with the upholstery completely removed or with it partially in position.
Press at those points illustrated. Check that the heater pad follows the compression of the cushion.
There must be no kinks or other defects in the heater pad when it is pressed.
Installing upholstery and front seat
Install:
-
the seat cushion upholstery.
-
the backrest cushion upholstery.
-
the front seat.
Finishing
Test the function of the heater pad
Start the seat heater and check the function.
NOTE: This check is not possible if the ambient temperature is too high.