S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
make the blind cover plugs/tape difficult to secure.
Note! To ensure the best results, it is recommended that two people press the spoiler onto the boot lid. Remember that the spoiler must be
installed symmetrically on the boot lid. Tips: Look on the inside of the boot lid. Check that the locating pins are in the centre of the drilled
holes.
Illustration A
-
Remove the protective film from the mounting tape for the spoiler.
Illustration B
-
Grip both ends of the spoiler. Carefully insert the locating pins in the holes in the boot lid
-
Press the spoiler firmly against the boot lid. (Otherwise there is a risk of the tape coming away when installing the screws and nuts)
-
Open the boot lid. Remove the two locating pins
-
Take the screws, nuts, washers and blind cover plugs from the kit
-
Tighten the screws, nuts and the washers for the spoiler. Tighten to 5 Nm (3.7 lbf.ft.).
Note! Do not exceed this torque.
-
Post-tighten the screws and nuts after 5 minutes
-
Press the blind cover plugs into the holes (check measurement 1054 mm) in the inner panel in the boot lid
-
Reinstall the panel on the underside of the boot lid.
Note! Leave the car indoors for 2 hours after carrying out the work. Do not wash the car for 48 hours.
