S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Remove:
-
the brackets on both sides of the climate control unit and the screws, 3 per bracket
-
the air duct
-
the 8 x screws for the cover.
Pull the cover at angle downwards/backwards.
Angle the heat exchanger up at the rear edge. Lift out the heat exchanger towards the driver's side.
Installation
Note! Note how the seal is located on the heat exchanger.
Install the heat exchanger and heat exchanger pipes through the seal.
The heat exchanger in the service kit has separate pipes.
Hint: To facilitate assembling the pipes, lubricate the ends with a little oil.
Note! Use new O-rings for the pipe ends.
Install the pipes at the connection to the heat exchanger pipes.