S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Remove:
-
the 2 x screws and the lead-in's right half, see image
-
the section that holds the heat exchanger and evaporator pipes apart.
Pull the heat exchanger pipes through the seal.
Seal the pipes to the heat exchanger so that the remaining coolant cannot run out.
Angle the heat exchanger up at the rear edge. Lift out the heat exchanger towards the passenger side.
Note! Note how the seal is located on the heat exchanger.
Installation
Note! Install a new seal carefully using the removed evaporator as a template.
Install:
-
the heat exchanger
-
the heat exchanger pipes through the seal.
Hint: To facilitate assembling the pipes, lubricate the ends with a little oil.
Note! Use new O-rings for the pipe ends.
Install the pipes at the connection to the heat exchanger pipes.