S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
-
Install the front engine block heater socket in the hole below, centre it in the hole. Tighten in the connector using a Torx screw (L=40 mm) and the
mounting plate from the kit.
-
Reinstall the bumper cover using the five clips and the two screws in the upper edge.
Applies to the C70
Preparations
-
Remove the covers for the nozzles for the headlamp washers on the right and left-hand sides. Carefully grip the cover. Pull the cover out until the
catch becomes accessible.
-
Press the catch up. Remove the cover. Do not damage the painted surfaces or the washer nozzles.
