S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
-
Remove the right-hand front wheel.
-
Remove the five screws holding the bumper cover at the right-hand wing liner.
-
Remove the nut holding the wing liner at the right-hand front member.
-
Bend the front edge of the wing liner up over the brake caliper.
Only applies to cars with an engine block heater
-
Cut off the tie strap above the locking sleeve.
-
Detach the wiring from the front intake from its clamps, to facilitate installation of the timer relay. If necessary, also detach the cable from the
engine block heater.
-
Remove the locking sleeve over the cable splice and separate the cables.