S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Applies to cars with an engine block heater and passenger compartment connector socket
-
Detach the wiring from the front intake from its clamps, to facilitate installation of the timer relay.
-
Detach the clamp that holds the junction connector at the stay.
-
Remove the junction connector with cables from the clamp and stay.
Applies to cars with an engine block heater and passenger compartment connector socket
-
Remove the sleeves from above the splices on the cables for the front intake, engine block heater and passenger compartment connector socket.
-
Remove the wiring from the junction connector.
-
Remove the holder from the junction connector. The holder must be used for the timer relay but the junction connector must not be used again.
-
Lubricate the O-rings on the cable from the front intake, timer relay and cable for passenger compartment connector socket (if applicable). Use
low temperature grease (part no. 1161417-9).
Note! Do not get any grease on the surfaces of the connector.