S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Air Door Actuator / Motor: Service and Repair
Actuator Recirculation
Actuator recirculation
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Preparatory work
Removing the glove compartment
Remove the glove compartment. See: Glove compartment See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair/Glove
Compartment.
Removal
Removing the damper motor module (DMM) for recirculation
Disconnect the connector.
Hint: Using a small electrician's screwdriver, pry up the connector at the lock. Pull the connector off.
Remove:
-
the 4 screws
-
the control module.
Installation
Installing the damper motor module (DMM) for recirculation
Install:
-
the control module in position. Adjust the shaft journal so that it goes in
-
the 4 screws. Tighten crosswise
-
the switch