S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Disconnect the rear connector (1) to the condenser, to the left of the right-hand headlamp. See the illustration.
Route the pipe/hose down to the compressor under the vehicle.
Installing the pipe/hose between the compressor and the condenser
Note! For tightening torques, see Specifications. See: Body and Frame/Specifications
Place the pipe/hose for the compressor in position by the upper connector to the condenser.
Install:
-
the pipe coupling, 1 M8. Ensure that the O-rings are securely located between the condenser and the pipe/hose. Tighten the screw
-
the pipe coupling by the compressor, 1 M8. Make sure the O-rings are securely located. Tighten the screw
Carry out finishing work. See: Finishing.
Pipe/hose between compressor and receiver (suction side), replacing
Removing the pipe/hose between the compressor and the receiver
Remove the lower/front pipe/hose connector (2) on the compressor.
