S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Remove:
-
the service valve using an extended 24 mm sleeve
-
the screw (2) at the condenser connection.
Installing the pipe / hose between the condenser and the expansion valve
Note! For tightening torques, see Specifications. See: Body and Frame/Specifications
Install the cap nut for the expansion valve.
Install:
-
the M8 screw on the condenser connection
-
the service valve. Tighten. See: Tightening torque See: Body and Frame/Specifications
-
the service valve cover.
Press in the hose into the mounting below the right-hand suspension turret.
Carry out finishing work. See: Finishing work (the same for all methods).
Pipe between expansion valve and evaporator, replacing
Removing the pipe between the expansion valve and the evaporator
Lift up the hose from the mounting below the right-hand suspension turret.
Remove:
-
the screw securing the air conditioning (A/C) pipes to the evaporator. See the illustration
-
the plastic clip holding the mounting block
-
the mounting block from the pipes.