S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
-
the oil pump's bolts, 4 pcs.
Carefully wiggle out the oil pump. Use a screwdriver at the pry lugs.
Carefully pull the oil pump past the crankshaft end.
Thoroughly clean the gasket surfaces and contact faces.
Checking the oil pump
Dismantle the oil pump.
Clean and check all parts.
Check for any damage and wear.
In case of defects, replace the oil pump.
Assembling oil pump
Place the outer and inner pump rotors in the oil pump housing. The inner pump rotor has a face-recessed surface, around the hole, for fitting against the
crankshaft. This face-recessed surface shall be placed facing against the seal ring in the oil pump housing.
Install the reducer valve's piston and spring.
Assemble the pump and tighten the screws according to: Tightening torque See: Engine, Cooling and Exhaust/Engine/Specifications/Mechanical
Specifications/Tightening Torque.
Removing coolant pump/timing belt cover