S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Manifold Pressure/Vacuum Sensor: Service and Repair
Manifold absolute pressure (MAP) sensor
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Removal
Removing the pressure sensor
Cut the tie strap for the pressure sensor cable harness. Disconnect the pressure sensor connector.
Remove:
-
the screws for the sensor
-
lift up the sensor.
Installation
Note! For tightening torques, see Specifications. See: Engine, Cooling and Exhaust/Engine/Specifications/Mechanical Specifications/Tightening
Torque
Installing the pressure sensor
Install:
-
the pressure sensor
-
screws for the pressure sensor. Tighten. Connect the connector for the pressure sensor
-
new tie strap for the pressure sensor wiring.