S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Oxygen Sensor: Service and Repair
Heated Oxygen Sensor (HO2S), Replacing
Heated Oxygen Sensor (HO2S), Replacing
NOTE: The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential
information in the illustrations is always correct.
Replacing components
Removing the front heated oxygen sensor HO2S)
Slacken off and disconnect the connector for the front heated oxygen sensor (HO2S).
Raise the vehicle.
Remove:
-
the lower engine cover
-
the front heated oxygen sensor (HO2S). Use tool 999 5543.
Installing the front heated oxygen sensor HO2S)
Install:
-
the front heated oxygen sensor (HO2S). the lower engine cover. Lower the vehicle.
-
Connect the connector for the front heated oxygen sensor (HO2S). Secure the cable harness in the clips and clamps.
Replacing components
Removing the rear heated oxygen sensor (HO2S)
Raise the vehicle. Disconnect the connector for the rear heated oxygen sensor (HO2S).
Disconnect the cable harness from the front SIPS member.
Remove the rear heated oxygen sensor (HO2S). Use tool 999 5543.
Installing the rear heated oxygen sensor (HO2S)
Install the rear floor hatch. Connect the connector for the rear heated oxygen sensor (HO2S) and secure the cable harness in the front SIPS member.
Lower the vehicle.
Finishing
Checks
Start the engine.
Check the function of the engine.
Check for leakage.