S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Caution! Make sure that the guides for the lower section are in the correct position.
Install:
-
a new gasket for the upper section of the intake manifold
-
the upper intake manifold. Tighten the screws alternately. Tighten. See: Tightening torque See: Engine, Cooling and
Exhaust/Engine/Specifications/Mechanical Specifications/Tightening Torque. Tighten the hose clamp to the mass air flow (MAF) sensor. Connect
the connector for the pressure sensor on the intake manifold
-
new tie strap for the cable harness.
Finishing
Checking injectors and pulsation dampers
Start the engine. Check the function of the engine. Check for leakage.