S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Control Module: Service and Repair
Transmission Control Module (TCM)
Operation number: 43715-2
Note! Some variation in the illustrations may occur, but the essential information is always correct.
Preparatory work
Information
Caution! The software can only be ordered when the control module is installed in the vehicle. VIDA reads off the new control module identity
which is required to order the correct software.
Caution! Wait one minute after the ignition has been switched off. The main relay must be voltage free before the control module can be
removed from the car. If the engine cooling fan (FC) runs on after the ignition has been switched off, wait until it stops. Then wait a further
minute.
Removing the battery negative lead
Ignition off.
Note! Shift the gear selector lever to neutral.
Disconnect the battery negative cable. See: See: Starting and Charging/Battery/Service and Repair/Procedures/Battery, Disconnecting
Removal
Removing the air cleaner (ACL) module